Ian & Pete cleared various debris out of the sump of the power unit, and started cleaning & painting sections of inlet air piping. Dave...supervised, as he is still recovering from being under the knife for a hernia and is excused duties for the moment. Mark cleaned & sorted another section of conduit for the generators, to go with the two sections he had previously done, so three down, 13 to go. This is not as easy as it sounds, as most of the lengths of conduits had been separated from each other for easier storage, so it was a case of multiple visits inside Repulse & our stores to find the right sections.
I test-fitted one of the new Z70 resistors, and found it fits the existing brackets perfectly. I just need to properly space the tapping bands, then it can be fitted permanently.